Home
Categories
About
login
join us
Cheap Network Analyzer UK - Frugal Shopping
×
Cheap Network Analyzer UK - Frugal Shopping
Add a product to the list
Categories
Check it out here
Groups
Check it out here
All Categories
Cheap Network Analyzer UK | Frugal Shopping
Disclaimer:
"Frug.al is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.co.uk"
Results
Shumo SMA-Type 50 Ohm NanoVNA Vector Network Analyzer Calibration Kit Load &Short &Open
jiangxindianliaojingyingbu
In stock
Brand New
See Details
Close
Go To Store
Remove product
See Details
Close
Product Features
Frequency: -6GHz, the standard load full-band standing wave is lower than 1,025.
A set of NanoVNA vector network analyzer calibration kits, including SMA open, SMA short, a 50Ω standard load, and the interface is SMA male (female thread).
Condition: 100% new.
The SMA load terminal is stainless steel with a low standing wave. 50 ohm imported stainless steel load, low standing wave, -6 GHz (1 MHz-6 GHz), the standing wave ratio is basically around 1.02.
NanoVNA SAA-2N V2.2 Vector Network Analyzer 50KHz-3GHz HF VHF UHF Antenna Analyzer Measuring S Parameters, Duplexer, Voltage Standing Wave Ratio, Phase, Delay, with 4 inch Display Metal Case
HTPOWER (7-14 days arrive)
In stock
Amazon Prime Approved
Brand New
See Details
Close
Go To Store
Remove product
See Details
Close
Product Features
▲ S-A-A-2 NanoVNA V2 3GHz vector network analyzer is a vector network analyzer with higher measurement frequency developed and produced according to LGPL license agreement and based on the design of OwOComm.
▲ SAA-2 / NanoVNA V2 uses a similar user interface to NanoVNA, but adopts a different technical architecture. SAA-2 / NanoVNA V2 does not load the initial calibration data at startup and does not automatically insert calibration data after the user changes the frequency. After the second start and frequency change, the calibration data must be recalibrated or recalled.
▲ Frequency range: 50kHz-3GHz System dynamic range (calibration): 70dB (up to 1.5GHz), 60dB (up to 3GHz) S11 noise floor (calibration): -50dB (up to 1.5GHz), -40dB (up to 3GHz) Scanning speed: 100 points / second Display: 2.8 inches, 320 x 240.
▲Display: 2.8 inches, 320 x 240 USB interface: Micro USB Power supply: USB, maximum charging current 1A Battery: 2000mAh lithium ion Battery connector: JST-XH 2.54mm.
▲Maximum scan point (on device screen): 201 Maximum scan point (USB): 1024 Port 2 return loss (1.5GHz): 20dB typ Port 2 return loss (3GHz): 13dB MIN VNA-QT software compatible system: Linux, Windows (7+), Mac OS planned.
Add new product